Benjamin Moore High Performance, Alkyd Urethane Enamel, Satin, Gallon
Benjamin Moore High Performance, HP2220 Alkyd Urethane Enamel is a versatile maintenance coating for interior and exterior surfaces. The surface-tolerant formula adheres to metal surfaces that may be marginally prepared, and the exceptional flow and leveling provides a smooth, uniform finish, with excellent protective qualities. This rust preventative coating can be applied directly to ferrous metal or used in combination with a Benjamin Moore® HP metal primer for increased corrosion protection.
For interior or exterior commercial and residential applications on metal equipment, machinery, metal doors and cabinets, storage tanks, metal buildings, fences, marine exposures (above water) and general maintenance painting.
As low as $88.19
- Dual purpose- primer and finish coat
- Durable rust preventative coating
- Versatile protection for metal substrates
| Series/Sub-Brand | High Performance |
|---|---|
| Type | Interior/Exterior |
| Size | Gallon |
| Brand | Benjamin Moore |
| Finish | Satin |
| Material | Oil-Based |
| Manufacturer Code | HP2220, CHP2220 |
Surface Preparation: Prior to painting any surface, area must be clean, dry and free of all grease, dirt, dust, oil and wax. Clean all surfaces using HP6000 Oil & Grease Emulsifier. Remove all remaining loose paint, rust and mill scale via Hand Tool Cleaning or Power Tool cleaning. Fill holes and cracks and sand smooth. Glossy surfaces must be fully deglossed. Moderate to heavily rusted areas must be thoroughly prepared and active rust should be properly removed.
Application: Stir thoroughly before and during use. Apply one or two coats. For best results, use a premium natural bristle brush and premium roller. Apply paint generously from unpainted area into wet area. This product can also be sprayed.
Spray, Airless:
Pressure / 1,500 – 2,500 PSI
Tip / 0.015 – 0.019
NOTE: Do not allow material to remain in hoses, gun or spray equipment. Thoroughly flush all equipment with thinner. No reduction is necessary. Do not apply if material, substrate or ambient temperature is below 45 °F(7.2°C ). Relative humidity should be below 90%. Do not apply if within 5 degrees of dew point of if rain is expected within 12 hours of application.
Coverage: 350-450 Sq. Ft. per gallon
Dry Time: To Touch in 2 hour, To Recoat in 12 hours with 77°F and 50% relative humidity
Clean Up: Clean all equipment immediately after using with paint thinner or HP7010
Write Your Own Review